Go make something®.

makeSEA Showcase Demo

This project demonstrates how makeSEA CMS for Magic Leap works.

Solar Water Distiller

This project is to design a 3d printable system which can clean polluted water.

Curate Demo

A demonstration collaboration space using Sharespace by makeSEA

Spatula Collection Version B with Teeth

This collection mimics the B Collection but with the addition of teeth for more grip! Use it as needed to mix, spread and lift materials in the kitchen, the craft room, garage... uses are endless!

Snap - Fit Cantilever Version B

The Snap Fit Cantilever B is like the Snap Fit Cantilever design except the hook has a less sharp angle, so that it is not permanent and can be disassembled. Hook angle is 45°.

Spatula Collection Version A with Teeth

It’s the same design as “Spatula A“ but the blade is toothed. Useful for distributing even amounts of all kind of gels on a surface. In the model the tooth size depends on the tooth distance.

Snap - Fit Round Version B

It’s a dismountable snap fit. The holding force is relatively low (depending on the hook width). The knob is the protruding middle part between two holes. If the two parts are snapped together, they can

Spatula Collection Version B

Same blade as “Spatula A” but with a different shaped handle. The handle in the STL files has a fixed size (60mm long, 12mm thick, 20mm width). Handle parameters and slant of blade front can be adjusted

Flexion Hinge

It’s recommended to use a flexible material (PETG, BDP, etc.). PLA breaks too quickly. The bending part needs to be as thin as possible in order to last for a while - larger thickness will cause more stress

HACAMAT MAKİNESİ

Spatula Collection Version A

This broad handled "spatula" is well suited for mixing, spreading and lifting of materials such as plaster and paint, but is also at home in the kitchen!

MCtest

This is a test.   This is only a test.  Do not attempt to adjust your set.

Chevrolet ZRV

Click here to edit your project summary.  You can include inline images if you prefer.

Interlocking Hinge

This collection has a hinge solution for almost every need. The hinge prints in one piece. The two parts are interlocking (can’t be taken apart).

Test

Click here to edit your project summary.  You can include inline images if you prefer.

hidrocell

Jars

These jars come in a variety of shapes and sizes and are fully scalable. Perfect for storing and organizing small items for the kitchen, craft room, playroom or garage.

Water Turbine

This project is to build a 3d-printable water turbine re-using the brushless motor - generator design. In contrast to the wind turbine this system should produce a considerable amount of energy.

makeSEA Brushless Motor - 60W

Setting itself apart from other 3D-printed motor prototypes, makeSEA’s brushless motor can be printed on most consumer-grade 3D printers and assembled by virtually anyone. It is fully functional, reliable
— 20 Items per Page
Showing 1 - 20 of 55 results.