Go make something.

Solar Water Distiller

This project is to design a 3d printable system which can clean polluted water.

Building Infrastructure

Click here to edit your project summary.  You can include inline images if you prefer.

Interlocking Hinge

This collection has a hinge solution for almost every need. The hinge prints in one piece. The two parts are interlocking (can’t be taken apart).

Water Turbine

This project is to build a 3d-printable water turbine re-using the brushless motor - generator design. In contrast to the wind turbine this system should produce a considerable amount of energy.

Snap - Fit Cantilever Version A

This Snap Fit is permanently locking - basically it can’t be dismounted. By designing a small hole at the location of the hook, the hook could be bent back by pushing a small pin through the hole (an

makeSEA Brushless Motor - 60W

Setting itself apart from other 3D-printed motor prototypes, makeSEA’s brushless motor can be printed on most consumer-grade 3D printers and assembled by virtually anyone. It is fully functional, reliable

Spatula Collection Version B

Same blade as “Spatula A” but with a different shaped handle. The handle in the STL files has a fixed size (60mm long, 12mm thick, 20mm width). Handle parameters and slant of blade front can be adjusted

Snap - Fit Clip Version A

Advantage: very short hole length (beam). The flexible part of the beam/hook is on the other side of the hole. Similar to the cantilever snap fit, the size of this flexible par depends on the material,

Torsion Hinge

In contrast to the flexing hinge, this hinge has thin parts, which are stressed only by torsion. The torsion bands are long enough to avaid plastic deformation.

Jars

These jars come in a variety of shapes and sizes and are fully scalable. Perfect for storing and organizing small items for the kitchen, craft room, playroom or garage.

Multi tool slider

A simple 3D printable sliding system to make straight cuts or carvings with a multi tool.

Fluke 8842A Replacement Parts

This is a L/R Handle replacement part for the Fluke 8842A Desktop Multimeter.

Half Dome

This is an experimental 3D modeling project of Half Dome in Yosemite, CA.

Spatula Collection Version A with Teeth

It’s the same design as “Spatula A“ but the blade is toothed. Useful for distributing even amounts of all kind of gels on a surface. In the model the tooth size depends on the tooth distance.

Hex Box

This one piece box with a flexible hinge comes in a variety of useful sizes and shapes. Great for storing and organizing those small items that always seem to get misplaced.

Cable Ties

More than just a cable tie. Because these versatile ties can be printed in many sizes and widths, they are suitable for many projects. Customize with color and use in the garden, workshop, office, or

Mammoth Mountain

This is an experimental model of Mammoth Mountain, CA.

helikopter disli sistemi

Snap - Fit Double Clip Version A

This Double Snap Fit is basically the same as two mirrored basic clips. It has the same advantages, but in addition the two symmetrical hooks hold the mountable part more evenly. With only one hook it

Flexion Hinge

It’s recommended to use a flexible material (PETG, BDP, etc.). PLA breaks too quickly. The bending part needs to be as thin as possible in order to last for a while - larger thickness will cause more stress
— 20 Items per Page
Showing 1 - 20 of 34 results.